Watchguard Firebox Edge

From DD-WRT Wiki

(Difference between revisions)
Jump to: navigation, search
Revision as of 15:08, 28 July 2011 (edit)
Sash (Talk | contribs)
(Serial port)
← Previous diff
Revision as of 17:10, 28 July 2011 (edit) (undo)
Sash (Talk | contribs)
(Hardware)
Next diff →
Line 13: Line 13:
=Hardware= =Hardware=
-*Intel IXP 422 @ 2663MHz+*Intel IXP 422 @ 266MHz
*6x 10/100Mbps ports (Marvell 88E6060) *6x 10/100Mbps ports (Marvell 88E6060)
*1x mPCI (optional WIFI) *1x mPCI (optional WIFI)
Line 33: Line 33:
===Internal=== ===Internal===
-serial pinout: +serial pinout: <br>
-1: 3.3V +1: 3.3V <br>
-2: Rx +2: Rx <br>
-3: Tx +3: Tx <br>
-4: GND +4: GND <br>
[[Category:Hardware]] [[Category:Hardware]]

Revision as of 17:10, 28 July 2011

This tutorial gives you infromation about the Watchguard Firebox Edge series which includes the models X10e(-W), X20e(-W) and X55e(-W)

Contents


Install DD-WRT

Via Serial Port

Reset

The device can be reset to factory defaults by holding down the reset button when powering up

Hardware

  • Intel IXP 422 @ 266MHz
  • 6x 10/100Mbps ports (Marvell 88E6060)
  • 1x mPCI (optional WIFI)
  • 128MB SD-RAM
  • 1MB NOR Flash
  • 64MB NAND Flash
  • 12V/1.2A PSU
  • 2x RS232
  • Backup battery (+)


(+) The switch on the PCB enables/disables the backup battery. Default is enabled. With it enabled going throught the factory reset procedure will restore the firmware but not your settings (local IP, admin logon etc...). Resetting with the switch off trully resets everything.

Serial port

You have to hold the reset button while powering on to see the boot up on the rear serial connector. Serial settings 115200 bps,8,N,1
Password: F5BA25AB44724fb5A6DD37554809CE34

Internal

serial pinout:
1: 3.3V
2: Rx
3: Tx
4: GND