Watchguard Firebox Edge

From DD-WRT Wiki

(Difference between revisions)
Jump to: navigation, search
Revision as of 14:56, 28 July 2011 (edit)
Sash (Talk | contribs)
(Install DD-WRT)
← Previous diff
Revision as of 14:56, 28 July 2011 (edit) (undo)
Sash (Talk | contribs)
(Hardware)
Next diff →
Line 20: Line 20:
*64MB NAND Flash *64MB NAND Flash
*12V/1.2A PSU *12V/1.2A PSU
-*1x RS232+*2x RS232
==Serial port== ==Serial port==
 +
 +Internal serial pinout is:
 +1: 3.3V
 +2: Rx
 +3: Tx
 +4: GND
 +
[[Category:Hardware]] [[Category:Hardware]]

Revision as of 14:56, 28 July 2011

This tutorial gives you infromation about the Watchguard Firebox Edge series which includes the models X10e(-W), X20e(-W) and X55e(-W)

Contents


Install DD-WRT

Via Serial Port

You have to hold the reset button while powering on to see the boot up on the rear serial connector. Serial settings 115200 bps,8,1,off.

redboot pw?

Hardware

  • Intel IXP 422 @ 2663MHz
  • 6x 10/100Mbps ports (Marvell 88E6060)
  • 1x mPCI (optional WIFI)
  • 128MB SD-RAM
  • 1MB NOR Flash
  • 64MB NAND Flash
  • 12V/1.2A PSU
  • 2x RS232

Serial port

Internal serial pinout is: 1: 3.3V 2: Rx 3: Tx 4: GND