WAN Port

From DD-WRT Wiki

(Difference between revisions)
Jump to: navigation, search
Revision as of 17:28, 22 November 2010 (edit)
Linlin911911 (Talk | contribs)
(把WAN变换成LAN端口使用(chinese))
← Previous diff
Current revision (18:18, 18 March 2018) (edit) (undo)
Ian5142 (Talk | contribs)
(Removed Advanced tutorials)
 
(2 intermediate revisions not shown.)
Line 1: Line 1:
 +{{languages}}
 +
When the WRT is used as an Access Point (AP) or repeater (WDS), the WAN port can easily be configured as a normal LAN port. When the WRT is used as an Access Point (AP) or repeater (WDS), the WAN port can easily be configured as a normal LAN port.
== Adding WAN Port to LAN Switch to use as an additional, normal LAN port== == Adding WAN Port to LAN Switch to use as an additional, normal LAN port==
-Note: Steps are true for firmwares current as of the author date of this article. v2.4, post SP2 firmwares. These steps were done with build 12307 (2009 06 17), widely regarded as stable. Other firmware builds of DD-WRT have the same or very similar steps.+Note: Steps are true for firmwares current as of the author date of this article. v2.4, post SP2 firmwares. These steps were done with build 12307 (2009 06 17). Other firmware builds of DD-WRT have the same or very similar steps.
# Open up the Web Interface to your DD-WRT Device # Open up the Web Interface to your DD-WRT Device
Line 10: Line 12:
The WAN port is now the same as the other LAN ports. The WAN port is now the same as the other LAN ports.
-== 把WAN变换成LAN端口使用(chinese)== 
-注意: 以下步骤适用于本文作者目前的固件。v2.4 SP2 之后的固件。以下步骤是用 build 12307 (2009 06 17)固件,基本认为是稳定版本。其它固件版本的步骤应该相同或类似。 
- 
-# 进入路由器网页“设置”页面。 
-# 将WAN连接类型设为“已禁用”。 
-# 然后,在本页面中间出现“WAN端口”选区,勾选“指派WAN口为交换口(WAN口变交换口)” 
-# 然后,页面下文的“应用”。 
- 
-至此WAN就可以当作普通的LAN端口使用。 
---- ----
[[Category:Wan]] [[Category:Wan]]
[[Category:Interfaces]] [[Category:Interfaces]]
-[[Category:Advanced tutorials]] 

Current revision


When the WRT is used as an Access Point (AP) or repeater (WDS), the WAN port can easily be configured as a normal LAN port.

[edit] Adding WAN Port to LAN Switch to use as an additional, normal LAN port

Note: Steps are true for firmwares current as of the author date of this article. v2.4, post SP2 firmwares. These steps were done with build 12307 (2009 06 17). Other firmware builds of DD-WRT have the same or very similar steps.

  1. Open up the Web Interface to your DD-WRT Device
  2. Set WAN 'Connection Type' to Disabled.
  3. Down the Basic Setup page, the option WAN Port appears. Check the box 'Assign WAN Port to Switch'.
  4. Save/Reboot

The WAN port is now the same as the other LAN ports.