WAN Port
From DD-WRT Wiki
(Difference between revisions)
Revision as of 04:04, 23 July 2009 (edit) S2s2 (Talk | contribs) (Article was way too complex, and some of the instructions were wrong or out of date.) ← Previous diff |
Current revision (18:18, 18 March 2018) (edit) (undo) Ian5142 (Talk | contribs) (Removed Advanced tutorials) |
||
(7 intermediate revisions not shown.) | |||
Line 1: | Line 1: | ||
+ | {{languages}} | ||
+ | |||
When the WRT is used as an Access Point (AP) or repeater (WDS), the WAN port can easily be configured as a normal LAN port. | When the WRT is used as an Access Point (AP) or repeater (WDS), the WAN port can easily be configured as a normal LAN port. | ||
== Adding WAN Port to LAN Switch to use as an additional, normal LAN port== | == Adding WAN Port to LAN Switch to use as an additional, normal LAN port== | ||
- | Note: Steps are true for firmwares current as of the author date of this article. v2.4, post SP2 firmwares. These steps were done with build 12307 (2009 06 17) | + | Note: Steps are true for firmwares current as of the author date of this article. v2.4, post SP2 firmwares. These steps were done with build 12307 (2009 06 17). Other firmware builds of DD-WRT have the same or very similar steps. |
# Open up the Web Interface to your DD-WRT Device | # Open up the Web Interface to your DD-WRT Device | ||
Line 11: | Line 13: | ||
The WAN port is now the same as the other LAN ports. | The WAN port is now the same as the other LAN ports. | ||
---- | ---- | ||
- | [[Category: | + | [[Category:Wan]] |
- | [[Category: | + | [[Category:Interfaces]] |
Current revision
English • Deutsch • Español • Français • Italiano • 日本語 • Polski • Português • Русский • Svenska • 中文(中国大陆) • 中文(台灣) • |
When the WRT is used as an Access Point (AP) or repeater (WDS), the WAN port can easily be configured as a normal LAN port.
[edit] Adding WAN Port to LAN Switch to use as an additional, normal LAN port
Note: Steps are true for firmwares current as of the author date of this article. v2.4, post SP2 firmwares. These steps were done with build 12307 (2009 06 17). Other firmware builds of DD-WRT have the same or very similar steps.
- Open up the Web Interface to your DD-WRT Device
- Set WAN 'Connection Type' to Disabled.
- Down the Basic Setup page, the option WAN Port appears. Check the box 'Assign WAN Port to Switch'.
- Save/Reboot
The WAN port is now the same as the other LAN ports.