Search results

From DD-WRT Wiki

You searched for Firmware_FAQ/se

Jump to: navigation, search

For more information about searching DD-WRT Wiki, see Help.

Showing below up to 20 results starting with #21.


View (previous 20) (next 20) (20 | 50 | 100 | 250 | 500).

No page title matches

Page text matches

  1. Linksys WRT320N v1.0 (5,744 bytes)
    8: *Flash/RAM: 8MB (serial) / 32MB
    17: ...s not work" for more info regarding how to hard reset this unit.'''
    21: *After initial flash, upgrades can use any non-trailed generic (not nv60k nor nv64k) K2....
    22: ...ini_wrt320n.bin), then from the Linksys webgui, reset to defaults.
    23: #Router default address is 192.168.1.1: Set your pc to a static IP e.g. 192.168.1.6 subnet 2...
  2. Netgear WNDR3300 (18,151 bytes)
    17: *Serial / JTAG: yes / no
    33: ** Please search before starting a new thread for any support ...
    35: * [[Firmware_FAQ#Where_do_I_download_firmware.3F|Build and downloa...
    41: *Can I use NEWD or NEWD2 builds?
    42: ...folder). Build download links are found in the [[Firmware_FAQ#Where_do_I_download_firmware.3F|Firmware FAQ]].
  3. Linksys WRT400N (3,467 bytes)
    41: * See: [[Firmware_FAQ#Where_do_I_download_firmware.3F|Where do I downlo...
    44: #Do a [[Hard_reset_or_30/30/30|Hard reset or 30/30/30]] on the router
    45: #Set a static IP on your computer to 192.168.1.7. Sub...
    47: ...he router (uplug the power from the router for 30 seconds and then plug it back in)
    48: ... and NOT a page that says Management Mode. If you see management mode, power cycle the router again.
  4. Linksys E1000 (4,980 bytes)
    19: #*'''Do not use a build bigger than 3712 KB (3801088 bytes)'''
    21: # Set a static IP on your computer e.g. 192.168.1.7 an...
    24: # Perform a [[#Performing a Hard Reset|hard]] reset.
    26: ...g>not</strong> give the reboot command. You will use this page to upgrade your firmware.
    27: # Browse to the downloaded firmware and click Upload.
  5. Asus RT-N66U (12,011 bytes)
    4: This 'Dark Night' presents significant risk to bricking that requires car...
    18: |[http://www.broadcom.com/press/release.php?id=s474934 Broadcom BCM4331]
    21: |3x3 (both bands) (see [https://forum.dd-wrt.com/phpBB2/viewtopic.php?t...
    41: !Serial header
    45: ===Reset button for Recovery===
  6. Buffalo WZR-D1800H (1,151 bytes)
    47: See [[Firmware_FAQ#Where_do_I_download_firmware.3F|Where do I downlo...
    49: ...ctice all the proper flashing procedures - hard resetting before and after flashing.
  7. Linksys E1200 (3,003 bytes)
    1: ...ge applies to version 1.'''</span> For version 2, see [[Linksys E1200v2]]
    42: ...unit with some other Linksys E-Series units that use nv60k builds!
    45: #Read the [[Firmware_FAQ]] and [http://www.dd-wrt.com/phpBB2/viewtopic.php...
    47: ...com/wiki/index.php/Hard_reset_or_30/30/30 hard] reset on router
    50: ...egrity, then power cycle the E1200 (unplug for 10 seconds).
  8. Netgear WNDR3700 (12,087 bytes)
    6: ...ich requires its own firmware build, whether you use stock firmware or DD-WRT. Installation of DD-WRT ...
    15: See [[Index:FAQ#Where_do_I_download_firmware.3F|Wher...
    17: ...DR3700 '''v1''' depending on the region you purchased your router from:
    30: Please note, a smaller sized build will be required for ...
    33: ...-06-2018-r35681%2Fnetgear-wndr3700%2F|here] by [[User:tmittelstaedt|tmittelstaedt]] on the version 1 N...
  9. D-Link DIR-615 rev D3 (4,639 bytes)
    3: ...rsion is also stuck on the bottom of the router itself. This means it's quick and easy to check the ha...
    5: ...ctory default IP for this router is 192.168.0.1, user is "admin", password is blank.
    8: * 4 MB board, so no need to use "micro" DD-WRT builds.
    10: ...sed in 2009?), so it's widely available for purchase new.
    15: ...o cannot be a NAS for a USB drive, nor can it be used for [[Printer Sharing]] of a USB printer.
  10. D-Link DIR-615 rev E3 (2,757 bytes)
    3: ...rsion is also stuck on the bottom of the router itself. This means it's quick and easy to check the ha...
    5: ...ctory default IP for this router is 192.168.0.1, user is "admin", password is blank.
    8: * 4 MB board, so no need to use "micro" DD-WRT builds.
    10: ...istribution, there are a lot of them around now, used
    14: ...o cannot be a NAS for a USB drive, nor can it be used for [[Printer Sharing]] of a USB printer.
  11. 刷机 (18,444 bytes)
    8: ...http://www.dd-wrt.com/site/support/router-database
    22: ...[[http://www.dd-wrt.com/site/support/router-database]] 将会帮助你确定你的设备所需的正...
    27: ... just going by what model you think you have - [[User:Clock|clock]].
    28: ...t may indicate how many files you need, etc (- [[User:Clock|clock]]).
    29: ... DD-WRT version for your device. You may need to use an SVN or experimental build.
  12. Netgear WNR2000V2 (7,316 bytes)
    39: Build Date: Wed Sep 9 14:33:22 CST 2009
    62: ...', but '''''board_data'' and ''nvram'' must be preserved.'''
    67: ...tgear_WNR2000v2 VERSION 2] MODEL ONLY!''' For V3 see [[Netgear_WNR2000V3|HERE]].
    68: ...vices|incompatible devices]] without u-boot mods (search the forums).
    70: #Read the [[Firmware_FAQ|Firmware FAQ]] and [http://www.dd-wrt.com/phpBB2/...
  13. D-Link DIR-810L (5,047 bytes)
    50: scan from offset 170000
    61: '''Be sure to use the correct revision directory for the A1/B1/C1 m...
    62: ...FAQ|Firmware FAQ]], SoC forum, and device thread (see [[#Notes|Notes]])
    66: ...eset the router from the GUI (or press and hold reset until the lights flash)
    67: ...s until the Tools->Firmware Upgrade'' can be accessed
  14. Linksys E3200 (4,483 bytes)
    49: ... a max of 20dBm then a setting of 100mW could be used as 20dBm = 100mW 17dBm = 50mW and so on.
    75: *If already running DD-WRT '''only use the NV60K build''' (or the trailed build)
    76: ...ding the newer NV60K.bin files for some Linksys E-series routers
    77: ...nfuse this with other E-series routers that must use only the NV64K builds
    78: ...this unit was added in build 17041''', so do not use an older build or you will brick your unit!
  15. Accueil/fr (2,049 bytes)
    12: |'''[[Firmware_FAQ/fr|FAQ]]''' <br/> Foire aux questions
    19: ...'[[Nouveau_tuto|Tutoriels ]]''' <br/>Tâches de base et avancées pour la configuration de votre route...
    29: ...Hardware DIY]]''' <br/> Hardware tutorials, JTAG, serial port, how to open, ...
    42: __NOEDITSECTION__
  16. Netgear R7000 (4,483 bytes)
    45: !Serial
    50: ...U is beneficial for running multiple simultaneous services on the router.
    52: ... throughput (download and upload). OEM firmware uses Broadcom's proprietary CTF (Cut-Through Forwardi...
    62: * OpenVPN and PPTP VPN server support
    67: ...rt.com trac SVN], but Kong builds are deprecated (see [[#Documentation|Documentation]] for differences...
  17. Netgear R6300v2 (9,244 bytes)
    3: The R6300v2 is an ARM device. '''DO NOT USE''' this guide for the MIPS [[Netgear_R6300|R6300 ...
    43: ... blue stripe, no "CH" on the bottom label, and whose firmware has no trailing "CH". The Initial Flash ...
    44: ...or further information about updating these units see this thread. [https://forum.dd-wrt.com/phpBB2/vi...
    76: ...including default username/password, are in flash section below)</li>
    79: ...load the "CH" initial flash file, if not you can use the regular initial flash file</li>
  18. Netgear WNDR4300 (5,843 bytes)
    4: ...ich requires its own firmware build, whether you use stock firmware or DD-WRT. Installation of DD-WRT ...
    19: Do not consider these build recommendations, check New Build threads fo...
    21: See [[Index:FAQ#Where_do_I_download_firmware.3F|Wher...
    40: ... green. Then open http://192.168.1.1 in a Web browser, and if a DD-WRT screen appears, flashing is com...
    42: * '''30/30/30 Reset''':
  19. Asus RT-AC88U (1,877 bytes)
    8: *Serial: yes, 4-pin header, unpopulated, internal, 3....
    20: ...sh from GUI, but research builds first, and see [[Firmware_FAQ#Where_do_I_download_firmware.3F|here]] for more i...
  20. TP-Link TL-WR841nd v9 (824 bytes)
    9: Also see: [[TP-LINK TL-WR841ND]]
    14: [[Firmware_FAQ#Where_do_I_download_firmware.3F|Where do I downlo...

View (previous 20) (next 20) (20 | 50 | 100 | 250 | 500).



Search in namespaces:

List redirects
Search for