Spanning Tree Protocol

From DD-WRT Wiki

(Difference between revisions)
Jump to: navigation, search
Revision as of 22:19, 15 July 2007 (edit)
Jeffman (Talk | contribs)
(Removed Spam)
← Previous diff
Revision as of 00:03, 14 August 2008 (edit) (undo)
Jf (Talk | contribs)
(External Links)
Next diff →
Line 4: Line 4:
Users of Comcast Cable should always disable this option and leave it disabled, as STP conflicts with the routers DHCP client for the WAN connection. Users of Comcast Cable should always disable this option and leave it disabled, as STP conflicts with the routers DHCP client for the WAN connection.
 +
 += How-to =
 +
 +Turn STP on like this.
 +
 +[[Image:wrt-set-stp.png]]
 +(wrt/index.asp)
 +
 +Check it like this.
 +[[Image:wrt-view-stp.png]]
 +(wrt/Networking.asp)
= External Links = = External Links =

Revision as of 00:03, 14 August 2008

The Spanning Tree Protocol (STP) is a protocol that tries to find the best route to use when multiple routes are available to the same destination. In these cases, mesh networks without STP enabled begin to experience Loopback. The need for STP occurs when your router is being used in a mesh network with multiple WDS-enabled repeaters, or in an ad hoc network with multiple ad hoc connections.

If your router is not being used in either of the given scenarios, then likely STP is not necessary. Therefore, it is recommended that you disable it.

Users of Comcast Cable should always disable this option and leave it disabled, as STP conflicts with the routers DHCP client for the WAN connection.

How-to

Turn STP on like this.

Image:wrt-set-stp.png (wrt/index.asp)

Check it like this. Image:wrt-view-stp.png (wrt/Networking.asp)

External Links

http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/sw_ntman/cwsimain/cwsi2/cwsiug2/vlan2/stpapp.htm