Netgear WNDR4500

From DD-WRT Wiki

Revision as of 06:43, 13 March 2015 by JNavas (Talk | contribs)
Jump to: navigation, search

Contents

Hardware Specs

CPU Broadcom BCM4706
CPU Speed 600 MHz
Flash ROM 128 MB
RAM 128 MB
Radios 2.4 GHz and 5 GHz
WLAN Support a/b/g/n
WLAN Max Speed 450 mbps on 2.4Ghz and 450mbps on 5Ghz
Antenna Location Internal
Switch 4x GigE LAN + 1 GigE WAN
USB 2x USB 2.0


Versions

There are two (2) versions of the WNDR4500 which have different power adapters and take different firmware.

Be careful to flash the correct firmware for your version!

Version WNDR4500 (v1) WNDR4500v2
Label on Router WNDR4500 WNDR4500v2
Power Adapter 12VDC 5A brick type with AC cord 12VDC 2.5A wall wart
Netgear Support WNDR4500 WNDR4500v2
Supported from DD-WRT build 21606 21656
Initial DD-WRT Flash 26138 mega for WNDR4500 26138 mega for WNDR4500v2


Flashing Instructions

It's always good practice to read Peacock Thread for reference on Broadcom-based routers.


Initial DD-WRT Installation

To go from stock Netgear firmware to DD-WRT on a WNDR4500 (using router DHCP):

  1. Connect PC to one of router's LAN ports with no other network connections to the PC.
  2. Turn on router, wait for Power light to go green, then reset router:
    1. Hold down Reset switch with a straightened paper clip for 20 seconds.
    2. After releasing Reset switch, router should reboot with much flashing of lights.
    3. Wait for Power light to go green again.
  3. Clear web browser cache.
  4. In web browser, go to http://192.168.1.1
  5. Click on Advanced > Administration > Router Update.
  6. Select special .chk firmware file you downloaded from table above.
  7. Wait up to 5 minutes after router says it is done for it to reboot and Power light to go green again.
  8. In web browser, go to http://192.168.1.1
  9. Verify DD-WRT successfully installed.
  10. Reset router (as above), and wait for router to reboot and Power light to go green again.
  11. In web browser, go to http://192.168.1.1
  12. Login and configure DD-WRT.


DD-WRT Upgrade

Download .bin (not .chk) file of desired build from DD-WRT FTP server.

Locate correct firmware in folder netgear-wndr4500 or netgear-wndr4500v2 on main page of build.

(Do not use folders broadcom_K26 or broadcom_K3X.)

Follow Initial DD-WRT Installation procedure except using DD-WRT Administration > Firmware Upgrade.


Build Information

In addition to 26138, another good build for this router is Kong 25015-SP1,
available only as DD-WRT upgrade (not initial flash).

Forum thread for reference: http://dd-wrt.com/phpBB2/viewtopic.php?t=145503