Netgear WNDR3400

From DD-WRT Wiki

(Difference between revisions)
Jump to: navigation, search
Revision as of 02:43, 6 February 2014 (edit)
JNavas (Talk | contribs)
(add recovery mode unbricking)
← Previous diff
Revision as of 02:44, 6 February 2014 (edit) (undo)
JNavas (Talk | contribs)
m (tweak)
Next diff →
Line 38: Line 38:
|- |-
! Switch ! Switch
-| 4x 100 + 1 100 WAN+| 4x 100 LAN + 1 100 WAN
|- |-

Revision as of 02:44, 6 February 2014


Important Notes

Only version 1 is supported. Versions 2 & 3 are not yet supported.

Use only K2.6 builds with nv64k in the name.

Read Peacock topic (at top of Broadcom Forum). Read it all. Carefully.

Hardware Specs

CPU Broadcom BCM4718A1
CPU Speed 480 MHz
Flash ROM 8 MB
Radios 2.4 GHz and 5 GHz
WLAN Support a/b/g/n
WLAN Max Speed 300 mbps on 2.4Ghz and 300mbps on 5Ghz
Antenna Location Internal
Switch 4x 100 LAN + 1 100 WAN
USB 1x USB 2.0

DD-WRT Installation

  1. There are two versions of this router with corresponding initial flash mini firmware. One is for Netgear branded routers and the other is for Cablevision routers.
  2. Do a factory reset (recessed button in the back), and upgrade with the appropriate mini firmware above. If it complains about downgrading, just Allow.
  3. To gain functionality of the usb port, upgrade to the big version or the mega version after flashing the mini version above.
  4. 30-30-30 reset router (as described in Peacock).

Build Notes


  • This is a good build for this router.


  • Upgrading to 21676 Big will brick this router! Use 21676 Mega instead.
  • This is otherwise a very good build for this router.


This router can be "bricked" (rendered inoperable) by flashing the wrong firmware; by not following the correct flashing procedure (in Peacock); or by flashing a bad build like 21676 Big.

Recovery mode method

This method, which works on the WNDR3800, may also work on the WNDR3400v1.

Pin short method

If you have bricked your router, and you are willing to accept the risk of damaging it beyond repair (as warned in Peacock), the router can often be recovered by shorting pins as described here.

  • Timing of the pin shorting is tricky -- power on, wait for the lights to flash, then try shorting a few times until the power light starts flashing steadily.
  • Next use tftp2 (with no password) to flash factory firmware.
  • After the flash, wait for at least a minute until the router boots up and the power light becomes steady green before resetting the router.

Revert to Factory Firmware

  1. Download official Netgear firmware
  2. Reset DD-WRT (recessed button in the back)
  3. Enable telnet under services
  4. Telnet to router (
  5. Issue the command "mtd erase linux" & wait ~3 mins
  6. tftp the official firmware to the router
    • tftp for windows [1] enter router ip, leave password blank, select official firmware file
  7. 30-30-30 reset router (as described in Peacock)