Netgear R9000
From DD-WRT Wiki
Contents |
Introduction
Hardware Specifications
This router can handle top VPN speeds, as of 2019.
Please note, Wireless-AD (60GHz) support is untested at this time, 2019.
Installation
Flash the factory-to-ddwrt file from either Kong or Brainslayer's download locations. See Where do I download firmware?
The Netgear firmware uses a default IP address of 192.168.1.1
- username: admin, password: password
Go to the Administration page - then Upgrade (or something similar).
You will see a notice about the file you uploaded being older than the firmware currently on the router. Click Yes to proceed.
The router will flash DD-WRT.
What a few minutes (5 min to be safe). Then try logging into DD-WRT at 192.168.1.1. You should see a screen asking you to create a username and password.