NEWD or VINT

From DD-WRT Wiki

(Difference between revisions)
Jump to: navigation, search
Revision as of 14:06, 6 February 2009 (edit)
Soulstace (Talk | contribs)
m (Better this way...the pipe symbol was too leet for some to comprehend..)
← Previous diff
Revision as of 14:08, 6 February 2009 (edit) (undo)
Soulstace (Talk | contribs)
m (Notes)
Next diff →
Line 19: Line 19:
=== Notes === === Notes ===
-''DO NOT RUN NEWD ON v1.0 ROUTERS'' Only install VINT builds. If you flash a NEWD build onto a V1.0 you ''will'' brick the router.+''DO NOT run NEWD on WRT54G v1.0 routers'' Only install VINT builds. If you flash a NEWD build onto a v1.0 you ''will'' brick the router.
-The <code> nvram show |grep wl0_corerev </code> command can also be run from dd-wrt's GUI on the Administration->Commands tab.+The command <code>nvram get wl0_corerev</code> can also be run from dd-wrt's GUI on the Administration->Commands tab.

Revision as of 14:08, 6 February 2009


More recent wireless drivers are not compatible with older radio chipsets, so dd-wrt builds are made available in two different flavors for backwards compatibility with order routers.

Which Build, NEWD or VINT?

If you have an older router, you might need to run a VINT build. VINT builds use an older wireless driver which is more compatible with the radio chipsets of Broadcom 4710 and 4712 CPUs. More recent routers using 4704, 4785, 5354 or 5365 CPUs should run the standard builds, sometimes labeled NEWD (NEW Driver)

To be sure of which version to install, check your router's core revision value. To view this, telnet into your router and run the following command. The value after wl0_corerev= is the number you're looking for.

nvram get wl0_corerev
  • wl0_corerev is Five and higher
Flash with standard NEWD builds
  • wl0_corerev is Four and lower
Flash with VINT builds

Notes

DO NOT run NEWD on WRT54G v1.0 routers Only install VINT builds. If you flash a NEWD build onto a v1.0 you will brick the router.

The command nvram get wl0_corerev can also be run from dd-wrt's GUI on the Administration->Commands tab.