Linksys WRT610N v2.0

From DD-WRT Wiki

(Difference between revisions)
Jump to: navigation, search
Revision as of 07:04, 23 January 2010 (edit)
Eng (Talk | contribs)
m (Minor cleanup)
← Previous diff
Revision as of 04:48, 29 January 2010 (edit) (undo)
M00nman (Talk | contribs)
(Installation)
Next diff →
Line 23: Line 23:
'''Make sure that you do not flash any build to your router that has the name of a different model router at the end of the filename.''' '''Make sure that you do not flash any build to your router that has the name of a different model router at the end of the filename.'''
 +
 +== Recovery (Unbricking) ==

Revision as of 04:48, 29 January 2010

Installation

NOTE: During configuration or flashing a device, the only cables that should be attached to the device are the network cable to your computer and the power cable.
Warning: This unit MUST use K2.6 firmware.
Make sure you use a firmware with wrt610nv2 in the filename like the one below.

ftp://dd-wrt.com/others/eko/V24-K26/svn13575/dd-wrt.v24-13575_NEWD-2_K2.6_mini_wrt610nv2.bin

a. Flash firmware through the Linksys WebGUI.

b. After a couple minutes you should see an "Update Completed Succesfully" Screen.

c. Wait...at least three minutes after that just to be safe.

d. Do a power cycle of the router. (Unplug the cord, count to 10 and plug it back in.)

e. Wait for the lights to return to normal, usually about 2 minutes.

f. Do a HARD reset. Wait. Check for the password page and login to change the password.

g. After you have DD-WRT on the router then you can flash a different firmware from this folder through the DD-WRT WebGUI.

ftp://dd-wrt.com/others/eko/V24-K26/svn13575/

Make sure that you do not flash any build to your router that has the name of a different model router at the end of the filename.

Recovery (Unbricking)