Linksys WRT600N

From DD-WRT Wiki

Revision as of 07:38, 27 June 2008 by Jmh9072 (Talk | contribs)
Jump to: navigation, search

Contents

Linksys WRT600N

Version 1.0

Pre-Build 3 Firmware

If your Version 1.0 firmware is prior to Build 3, you can simply TFTP the firmware to the router or use the web interface.

Flashing DD-WRT from v1.01.33 build 3 or earlier

Simply use TFTP or the web utility to flash DD-WRT from stock firmware. Unlike other models, you can go to the mega version directly since the WRT600N does not expect any special headers (it accepts generic images [HDR0]) As usual, reset before and after each flash. Do not use firmware prior to v24!

Flashing DD-WRT from v1.01.35 build 5 or later

Simply flash using the steps indicated in the v1.1 section below.

Reverting to Stock Firmware

Simply reset and flash the stock image via TFTP or through the web interface. Make sure to reset after flashing.

Version 1.1

Flashing DD-WRT

Download this trailed version of dd-wrt v24-9774. It can be flashed directly from the web interface or via TFTP. To flash it, simply go to Administration -> Firmware Upgrade and begin the upload. After you upload it you should flash the latest mega firmware from the /downloads/others/Eko/V24_TNG folder if it is available. Remember to erase the firmware either via telnet or via hard reset after you upload the latest firmware.

Reverting to Stock Firmware

Simply reset and flash the stock image via TFTP or through the web interface. Make sure to reset after flashing.

LEDs and Reset Button Don't Work

Top men are working on resolving the LED issues. The power, security, and USB LEDs still need to be fixed.