Linksys WRT54G v3.0

From DD-WRT Wiki

Revision as of 15:57, 6 November 2017 by Jeremywh7 (Talk | contribs)
Jump to: navigation, search

Initial Flash

NOTE: During device flash, it is recommended to connect the router to the computer only, via ethernet, and to clear the internet browser cache. Alternatively, pressing Ctrl-F5 will force a cache-bypass refresh of the current page.

  1. Carefully read the Peacock announcement in the Broadcom forum
  2. Restore factory defaults with the Linksys firmware.
  3. Using the Linksys firmware upgrade page, upgrade to the trailed 14929 mini build (https)
  4. Wait for five minutes
  5. Login to the DD-WRT GUI at 192.168.1.1
  6. Do a Factory Defaults (GUI) or hard reset
  7. Wait until you can again login at 192.168.1.1
  • If problems are encountered, upgrade to latest firmware for WRT54Gv3 and retry

Updating DD-WRT Firmware

  • Refer to the Peacock announcement for recommended builds. Do not use the Router Database.
  • For newer builds, refer to "New Build" threads, or those specific to this model.
  • This can run any broadcom folder build except mega. Do not use k26 nor k3x.
  1. It is recommended to reset prior to flashing. Administration > Factory Defaults
  2. Go to the DD-WRT Administration -> Firmware Upgrade page and select the downloaded firmware
  3. Wait six minutes to flash
  4. Reset after flashing.
  5. Access the dd-wrt GUI at 192.168.1.1, set a username and password
  • Do not restore settings from a backup unless from the exact same build file
  • Newer is not always better, and always reference the forum for New Build threads.
  • Builds are located: ftp or https