Linksys WRT54G v3.0

From DD-WRT Wiki

Revision as of 10:44, 30 April 2010 by Glenn (Talk | contribs)
Jump to: navigation, search

How To Flash

NOTE: During configuration or flashing a device, the only that should be hooked to the device is the computer and power.

Just basically followed the instructions for v1.0. some slight differences: did not use IE. I used Firefox on linux (x86 ubuntu) without a hitch, and followed these steps:

  1. Restore factory defaults with the original Linksys firmware.
  2. Upgrade to Linksys latest firmware for my router (as stated above, read fine print to get right firmware)
  3. Then upgrade to dd-wrt.v24-12548_VINT_mini.bin I also got to the Continue page, but never got the DD-WRT GUI.
  4. Hold the reset button for 30 seconds (not power cycle)
  5. got to dd-wrt nice and easy.
  6. Upgraded to dd-wrt.v23_wrt54g.bin. note that i used the wrt54g-specific binary.
  7. And everything worked after this.