Linksys WRT54G v3.0
From DD-WRT Wiki
(Difference between revisions)
Revision as of 06:42, 28 December 2009 (edit) DHC DarkShadow (Talk | contribs) ← Previous diff |
Revision as of 15:56, 21 February 2010 (edit) (undo) DHC DarkShadow (Talk | contribs) m (→How To Flash) Next diff → |
||
Line 1: | Line 1: | ||
== How To Flash == | == How To Flash == | ||
+ | <font color=red><big>'''NOTE:'''</big></font> '''During configuration or flashing a device, the only that should be hooked to the device is the computer and power.'''<br> | ||
Just basically followed the instructions for v1.0. some slight differences: did not use IE. I used Firefox on linux (x86 ubuntu) without a hitch, and followed these steps: | Just basically followed the instructions for v1.0. some slight differences: did not use IE. I used Firefox on linux (x86 ubuntu) without a hitch, and followed these steps: |
Revision as of 15:56, 21 February 2010
How To Flash
NOTE: During configuration or flashing a device, the only that should be hooked to the device is the computer and power.
Just basically followed the instructions for v1.0. some slight differences: did not use IE. I used Firefox on linux (x86 ubuntu) without a hitch, and followed these steps:
- Restore factory defaults with the original Linksys firmware.
- Upgrade to Linksys latest firmware for my router (as stated above, read fine print to get right firmware)
- Then upgrade to dd-wrt.v24-12548_VINT_mini.bin I also got to the Continue page, but never got the DD-WRT GUI.
- Hold the reset button for 30 seconds (not power cycle)
- got to dd-wrt nice and easy.
- Upgraded to dd-wrt.v23_wrt54g.bin. note that i used the wrt54g-specific binary.
- And everything worked after this.