Linksys WRT54G v3.0
From DD-WRT Wiki
(Difference between revisions)
Revision as of 22:02, 29 September 2009 (edit) DHC DarkShadow (Talk | contribs) (New page: Just basically followed the instructions for v1.0. some slight differences: did not use IE. I used Firefox on linux (x86 ubuntu) without a hitch, and followed these steps: # Restore facto...) ← Previous diff |
Revision as of 04:59, 30 September 2009 (edit) (undo) DHC DarkShadow (Talk | contribs) Next diff → |
||
Line 1: | Line 1: | ||
+ | |||
+ | == How To Flash == | ||
+ | |||
Just basically followed the instructions for v1.0. some slight differences: did not use IE. I used Firefox on linux (x86 ubuntu) without a hitch, and followed these steps: | Just basically followed the instructions for v1.0. some slight differences: did not use IE. I used Firefox on linux (x86 ubuntu) without a hitch, and followed these steps: | ||
Revision as of 04:59, 30 September 2009
How To Flash
Just basically followed the instructions for v1.0. some slight differences: did not use IE. I used Firefox on linux (x86 ubuntu) without a hitch, and followed these steps:
- Restore factory defaults with the original Linksys firmware.
- Upgrade to Linksys latest firmware for my router (as stated above, read fine print to get right firmware)
- Then upgrade to dd-wrt.v24-12548_VINT_mini.bin I also got to the Continue page, but never got the DD-WRT GUI.
- Hold the reset button for 30 seconds (not power cycle)
- got to dd-wrt nice and easy.
- Upgraded to dd-wrt.v23_wrt54g.bin. note that i used the wrt54g-specific binary.
- And everything worked after this.