Linksys WRT310N v2.0

From DD-WRT Wiki

Revision as of 01:30, 13 December 2010 by NiteSnow (Talk | contribs)
Jump to: navigation, search

1. Method A) While on, push and hold down the reset button continously for 30 seconds, unplug the power while continuing to hold for another 30 seconds, then plug back in while continuing to hold reset button for a final 30 seconds. (90 second button hold-down time)

Method B) plug the router in and hold down the reset button imediatly for 5 seconds.

2. Go to http://192.168.1.1/ and you'll see a "management" page with two options, to upload a new firmware and Reset NVRAM, Click 'Reset NVRAM' Wait a few seconds and then follow step one with the method that worked for you to update the firmware by going to http://192.168.1.1/ and clicking 'Upload a new firmware' and selecting one of the files mentioned below

YOU NEED TO FLASH MINI FIRST

Only use Broadcom K26 firmware images this one works and it's stable dd-wrt.v24-15778_NEWD-2_K2.6_mini_wrt310nv2.bin you may also flash this build afterwards if you want IPv6 support dd-wrt.v24-15778_NEWD-2_K2.6_std_nokaid_small.bin

After the upload completes, wait 3 minutes to let the router 'settle down' after the 'upgrade successful' message.

3. Now unplug your router for a minute, then plug back in. Go to http://192.168.1.1/ and you should see DD-WRT's control panel your router is now flashed to DD-WRT have fun and configure your router to your liking

Do not try to over clock this router or change the clock as stated previously keep it at 300Mhz or else it can and or will over heat