Linksys WRT310N v1.0

From DD-WRT Wiki

(Difference between revisions)
Jump to: navigation, search

DHC DarkShadow (Talk | contribs)
(New page: The WRT310N accepts ''only'' the mini, standard, and VPN builds; '''no other versions are supported''' on this device. Do not even attempt to flash it with the micro (does not support gig...)
Next diff →

Revision as of 20:59, 29 September 2009

The WRT310N accepts only the mini, standard, and VPN builds; no other versions are supported on this device. Do not even attempt to flash it with the micro (does not support gigabit ethernet so switch will not work for LAN ports) or mega-build (requires 8 MB of flash, WRT310N only has 4 MB), you will end up with a non-responding router or worse, a very expensive brick! Flashing a virgin WRT310N with the default Linksys firmware will require a special "trailed" mini-build to be flashed first. As of May 27, 2009 you should use a build from the BS Broadcom folder with a build date of 5/21/2009 for the initial flash. The name of this file specifically is "dd-wrt.v24_mini_wrt310n.bin". You may proceed to flash it with a generic STD or VPN build next. Remember to do the 30/30/30 Hard Reset after every successful flash. It is absolutely essential.

The proper process for flashing is found at note 1 of the peacock announcement: http://www.dd-wrt.com/phpBB2/viewtopic.php?t=51486

You can download the mini310N.bin firmware from this folder: ftp://dd-wrt.com/others/eko/BrainSlayer-V24-preSP2/08-19-09-r12672/broadcom/


Recovery information available in this thread.