Linksys WRT150N

From DD-WRT Wiki

(Difference between revisions)
Jump to: navigation, search
Revision as of 03:10, 6 October 2009 (edit)
Donny (Talk | contribs)

← Previous diff
Current revision (22:40, 6 October 2009) (edit) (undo)
LoganA (Talk | contribs)
(Redirecting to Linksys WRT150N & WRT160N)
Line 1: Line 1:
-The process for flashing the WRT150N and the WRT160N v.1 ONLY are the same. V.2 and V.3 of the 160n ARE NOT SUPPORTED. Do NOT try to flash those versions with this process.+#REDIRECT [[Linksys WRT150N & WRT160N]]
- +
-# Read Note 1 of the peacock announcement
-# Read Note 3 of the peacock announcement+
-# Download svn 12548 NEWD_Mini.bin (NOT NEWD2!)
-# Do a HARD reset on your router+
-# Plug a cable into the lan port of the router and your computer, and disable any wireless to the computer. Disable all firewalls and virus protection. (Setting your computer to a static IP should not be required)+
-# Set your browser to This will open up the linksys webgui+
-# Enter the username admin and password admin+
-# Go to the administration tab. Click on firmware upgrade.+
-# BROWSE to the 12548 NEWD_Mini.bin file you downloaded.+
-# Click on the upgrade button and WAIT for the upgrade successful message.+
-# Power cycle your router. (very important) WAIT until you can relogin at
-# Do a PROPER HARD 30-30-30 reset on your router (very important) WAIT until you can login at
-# Click on any tab. Reset your username/password by TYPING in a new username/password+
-# Configure your router+
- +
-You can now upgrade to any generic dd-wrt build except Mega and Micro. Be sure to always to a hard reset prior to flashing another build, do a power cycle followed by another hard reset after flashing, and NEVER re-use a configuration file from a previous build or another router. Reconfigure from scratch.+
- +
-[[Category: Linksys]]+

Current revision

  1. REDIRECT Linksys WRT150N & WRT160N