Linksys E2000

From DD-WRT Wiki

Revision as of 02:17, 29 December 2010 by Buddee (Talk | contribs)
Jump to: navigation, search


E2000 Hardware Specs

CPU Broadcom BCM4717A
CPU Speed 354 MHz
Flash ROM 8 MB
Radio 1x 2.4 GHz or 5 GHz selectable
WLAN Support a/b/g/n
WLAN Max Speed 300 mbps
Antenna Location Internal
Switch 4x GigE + 1 WAN

Flashing instructions for the E2000

1) Disconnect all cables and wireless clients.

2) Do a 30/30/30 reset on router

3) Connect 1 Lan cable to pc doing the flash.

4) Log into Web Interface and flash the firmware

5) Wait 5 minutes until WAN light turns on.

6) Power cycle by unplugging E2000 for 30 secs.

7) Plug E2000 back in and wait about 5 minutes until it finishes booting.

8 ) Do a 30/30/30 reset on router.

9) Wait 3 minutes and log into web interface.

As of July 2010 you can only use the trailed builds with the e2000 name in it for initial flashing and nothing else, using other bin's without the e2000 name in it for initial flashing may result in a bricked unit! After you have dd-wrt installed to your unit, you can then use the e2k-e3k.bin's for upgrading to newer builds.

DD-WRT E2000 Build information

The latest builds for this unit can be currently found in the FTP. Support was added in 14826 and on.

Eko K2.6 NEWD-2 Builds

Brainslayer added E2000 Support from 14929 and on and builds are to be found in the broadcom_K26 folder of his build branch.

Also it has been asked about the builds with e2k-e3k name in them, these builds are for if you already have those units flashed with dd-wrt, you can simply use one of those builds to upgrade, but the initial flash should always be done with the trailed build (build with the unit only name in it) linked above.

Some useful tips

I have noticed with these style of linksys units, cooling can be very important to its performance, thus I have done a nice easy mod that will allow air flow for under the unit. Check this post for details. -buddee