Linksys E2000

From DD-WRT Wiki

Revision as of 10:18, 5 August 2010 by Buddee (Talk | contribs)
Jump to: navigation, search

This page reserved for Linksys E2000 only

Currently this page is a work in progress...



Flashing instructions for the E2000

1) Disconnect all cables and wireless clients.

2) Do a 30/30/30 reset on router.

3) Connect 1 Lan cable to pc doing the flash.

4) Log into Web Interface and flash the firmware ftp://ftp.dd-wrt.com/others/eko/V24-K26/svn14853/dd-wrt.v24-14853_NEWD-2_K2.6_big-e2000.bin

5) Wait 5 minutes until WAN light turns on.

6) Power cycle by unplugging E2000 for 30 secs.

7) Plug E2000 back in and wait about 5 minutes until it finishes booting.

8 ) Do a 30/30/30 reset on router.

9) Wait 3 minutes and log into web interface.

As of July 2010 you can only use the trailed builds with the e2000 name in it and nothing else, using other bin's without the e2000 name in it may result in a bricked unit!


DD-WRT E2000 Build information

The latest builds for this unit can be currently found in the FTP. Support was added in 14826 and on.

ftp://ftp.dd-wrt.com/others/eko/V24-K26/

Also it has been asked about the builds with e2k-e3k name in them, these builds are for if you already have those units flashed with dd-wrt, you can simply use one of those builds to upgrade, but the initial flash should always be done with the trailed build (build with the unit only name in it) linked above.