LaFonera Hardware Disassembling
From DD-WRT Wiki
(Difference between revisions)
Revision as of 01:38, 12 February 2007 (edit) Wildblue (Talk | contribs) ← Previous diff |
Revision as of 01:58, 12 February 2007 (edit) (undo) Wildblue (Talk | contribs) Next diff → |
||
Line 1: | Line 1: | ||
- | Back to [[La_Fonera| | + | Back to [[La_Fonera|LaFonera mainpage]] |
== Inside the fon router== | == Inside the fon router== | ||
Line 20: | Line 20: | ||
- | ==Disassembling the | + | ==Disassembling the LaFonera router== |
Remove the mounting screws that are located under the rubber paddings: | Remove the mounting screws that are located under the rubber paddings: |
Revision as of 01:58, 12 February 2007
Back to LaFonera mainpage
Inside the fon router
As the router is small, it does not provide any additional LAN ports. One WAN port , DC input and the External RP-SMA connector with antenna can be seen in the picture below.
Disassembling the LaFonera router
Remove the mounting screws that are located under the rubber paddings:
Remove the antenna:
Pry off the white casing using a flathead driver:
Below you can see the top side of the main board. It seems to have one additonal antenna soldering point.
There is a serial port connector next to the two capacitors.
The bottom side of the board:
((The text on this Wiki-page was taken from http://sodoityourself.com/inside-the-fon-router/)