LaFonera Hardware Disassembling
From DD-WRT Wiki
(Difference between revisions)
Revision as of 02:15, 2 March 2007 (edit) Wildblue (Talk | contribs) ← Previous diff |
Revision as of 02:55, 2 March 2007 (edit) (undo) Wildblue (Talk | contribs) Next diff → |
||
Line 57: | Line 57: | ||
==Refrences== | ==Refrences== | ||
* http://sodoityourself.com/inside-the-fon-router/ do it yourself LaFonera guide | * http://sodoityourself.com/inside-the-fon-router/ do it yourself LaFonera guide | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | ---- | ||
+ | |||
+ | this page was made by [[User:wildblue|wildblue!]] |
Revision as of 02:55, 2 March 2007
You are here: DD-WRT wiki mainpage / LaFonera / Hardware / Disassembling
Inside the fon router
As the router is small, it does not provide any additional LAN ports. One WAN port , DC input and the External RP-SMA connector with antenna can be seen in the picture below.
Disassembling the LaFonera router
Remove the mounting screws that are located under the rubber paddings:
Remove the antenna:
Pry off the white casing using a flathead driver:
Below you can see the top side of the main board. It seems to have one additonal antenna soldering point.
There is a serial port connector next to the two capacitors.
The bottom side of the board:
Refrences
- http://sodoityourself.com/inside-the-fon-router/ do it yourself LaFonera guide
this page was made by wildblue!