LaFonera Hardware Disassembling
From DD-WRT Wiki
(Difference between revisions)
Revision as of 03:02, 11 February 2007 (edit) Wildblue (Talk | contribs) ← Previous diff |
Revision as of 03:14, 11 February 2007 (edit) (undo) Wildblue (Talk | contribs) Next diff → |
||
Line 18: | Line 18: | ||
- | + | ==Disassembling the Fonera router== | |
Remove the mounting screws that are located under the rubber paddings: | Remove the mounting screws that are located under the rubber paddings: |
Revision as of 03:14, 11 February 2007
Inside the fon router
As the router is small, it does not provide any additional LAN ports. One WAN port , DC input and the External RP-SMA connector with antenna can be seen in the picture below.
Disassembling the Fonera router
Remove the mounting screws that are located under the rubber paddings:
Remove the antenna:
Pry off the white casing using a flathead driver:
Below you can see the top side of the main board. It seems to have one additonal antenna soldering point.
There is a serial port connector next to the two capacitors.
The bottom side of the board:
((The text on this Wiki-page was taken from http://sodoityourself.com/inside-the-fon-router/)