LaFonera Hardware Disassembling
From DD-WRT Wiki
(Difference between revisions)
Revision as of 08:21, 22 March 2007 (edit) Guerby (Talk | contribs) m (fix typo) ← Previous diff |
Current revision (12:05, 14 May 2010) (edit) (undo) Glenn (Talk | contribs) (-cat) |
||
(7 intermediate revisions not shown.) | |||
Line 1: | Line 1: | ||
- | + | ||
- | [[Category: | + | [[Category:LaFonera_Hardware_(en)]] |
- | You are here: '''[[Main_Page|DD-WRT wiki mainpage]] / [[ | + | You are here: '''[[Main_Page|DD-WRT wiki mainpage]] / [[LaFonera_(en)|LaFonera]] / [[:Category:LaFonera_Hardware_(en)|Hardware]] / Disassembling''' |
== Inside the fon router== | == Inside the fon router== | ||
Line 55: | Line 55: | ||
- | == | + | ==References== |
* [[LaFonera_Info_Hardware-Specifications|Hardware Specification]] | * [[LaFonera_Info_Hardware-Specifications|Hardware Specification]] | ||
* http://sodoityourself.com/inside-the-fon-router/ do it yourself LaFonera guide | * http://sodoityourself.com/inside-the-fon-router/ do it yourself LaFonera guide | ||
- | |||
Current revision
You are here: DD-WRT wiki mainpage / LaFonera / Hardware / Disassembling
[edit] Inside the fon router
As the router is small, it does not provide any additional LAN ports. One WAN port , DC input and the External RP-SMA connector with antenna can be seen in the picture below.
[edit] Disassembling the LaFonera router
Remove the mounting screws that are located under the rubber paddings:
Remove the antenna:
Pry off the white casing using a flathead driver:
Below you can see the top side of the main board. It seems to have one additonal antenna soldering point.
There is a serial port connector next to the two capacitors.
The bottom side of the board:
[edit] References
- Hardware Specification
- http://sodoityourself.com/inside-the-fon-router/ do it yourself LaFonera guide
this page was made by wildblue!