LaFonera Hardware Disassembling
From DD-WRT Wiki
(Difference between revisions)
Revision as of 02:12, 28 June 2007 (edit) Wildblue (Talk | contribs) m (reworked category support) ← Previous diff |
Revision as of 19:36, 10 August 2007 (edit) (undo) Wildblue (Talk | contribs) m (reworked category support) Next diff → |
||
Line 3: | Line 3: | ||
[[Category:LaFonera_Hardware]] | [[Category:LaFonera_Hardware]] | ||
[[Category:LaFonera_Hardware_(en)]] | [[Category:LaFonera_Hardware_(en)]] | ||
- | You are here: '''[[Main_Page|DD-WRT wiki mainpage]] / [[LaFonera|LaFonera]] / [[ | + | You are here: '''[[Main_Page|DD-WRT wiki mainpage]] / [[LaFonera|LaFonera]] / [[LaFonera_Hardware_(en)|Hardware]] / Disassembling''' |
== Inside the fon router== | == Inside the fon router== |
Revision as of 19:36, 10 August 2007
You are here: DD-WRT wiki mainpage / LaFonera / Hardware / Disassembling
Inside the fon router
As the router is small, it does not provide any additional LAN ports. One WAN port , DC input and the External RP-SMA connector with antenna can be seen in the picture below.
Disassembling the LaFonera router
Remove the mounting screws that are located under the rubber paddings:
Remove the antenna:
Pry off the white casing using a flathead driver:
Below you can see the top side of the main board. It seems to have one additonal antenna soldering point.
There is a serial port connector next to the two capacitors.
The bottom side of the board:
Refrences
- Hardware Specification
- http://sodoityourself.com/inside-the-fon-router/ do it yourself LaFonera guide
- More LaFonera disassembly in High-Res
this page was made by wildblue!