LaFonera Hardware Disassembling
From DD-WRT Wiki
(Difference between revisions)
Revision as of 02:55, 2 March 2007 (edit) Wildblue (Talk | contribs) ← Previous diff |
Revision as of 08:20, 22 March 2007 (edit) (undo) Guerby (Talk | contribs) (add link to hw spec) Next diff → |
||
Line 56: | Line 56: | ||
==Refrences== | ==Refrences== | ||
+ | |||
+ | * [[LaFonera_Info_Hardware-Specifications|Harware Specification]] | ||
* http://sodoityourself.com/inside-the-fon-router/ do it yourself LaFonera guide | * http://sodoityourself.com/inside-the-fon-router/ do it yourself LaFonera guide | ||
Revision as of 08:20, 22 March 2007
You are here: DD-WRT wiki mainpage / LaFonera / Hardware / Disassembling
Inside the fon router
As the router is small, it does not provide any additional LAN ports. One WAN port , DC input and the External RP-SMA connector with antenna can be seen in the picture below.
Disassembling the LaFonera router
Remove the mounting screws that are located under the rubber paddings:
Remove the antenna:
Pry off the white casing using a flathead driver:
Below you can see the top side of the main board. It seems to have one additonal antenna soldering point.
There is a serial port connector next to the two capacitors.
The bottom side of the board:
Refrences
- Harware Specification
- http://sodoityourself.com/inside-the-fon-router/ do it yourself LaFonera guide
this page was made by wildblue!