Internal device network

From DD-WRT Wiki

Revision as of 13:35, 16 May 2010 by Glenn (Talk | contribs)
Jump to: navigation, search

Your network device's (commonly known as a "router") has an internal network. The default internal device networks connects the physical(=hardware):

  • internal switch
  • wireless access point

with the network processor (ARM, mips...).

In the network processor, via the DD-WRT user interface (or the manufacturers firmware), you can define, limited by software implementation and hardware possibilities, how the hardware is logically interconnected to user created software network services.

List of possible software network services:

  • OSI layer 2 interconnection, ethernet address routing; bridge (ca.= software switch)
  • OSI layer 3 interconnection; a software router
  • OSI layer 2-7 moderation, ip address transparent/bridging firewall, OSI layer 2-7 firewall
  • OSI layer 3-7 moderation; common firewall, OSI layer 3-7 firewall

The software network services is connected, by the user, to physical or logical network interface. The interfaces might be a:

  • physical interfaces might be labelled eth0, eth1...
  • logical might be a bridge (=switch) labelled br0, br1...
  • logical vlan labelled vlan0, vlan1....

and maybe:

The default internal device networks in a non-802.11n network device - specifically the default configuration of a V23-SP2 installation on a WRT54G v2. In a network device containing a 802.11n wireless access point the internal numbering of ports, bridges and vlans are different.
The default internal device networks in a non-802.11n network device - specifically the default configuration of a V23-SP2 installation on a WRT54G v2. In a network device containing a 802.11n wireless access point the internal numbering of ports, bridges and vlans are different.