Hard reset or 30/30/30

From DD-WRT Wiki

(Difference between revisions)
Jump to: navigation, search
Revision as of 22:58, 17 August 2008 (edit)
Soulstace (Talk | contribs)
m (wording)
← Previous diff
Revision as of 11:42, 19 August 2008 (edit) (undo)
Soulstace (Talk | contribs)
m (erasing nvram)
Next diff →
Line 1: Line 1:
-<div style="padding-left:10px; border-color:red; border-style:dotted; font-weight:normal; padding-right:5px"><font color=red><u>WARNING</u>: '''DO NOT''' attempt to reset or power cycle the router while it is still in the process of flashing (upgrading)! Wait a couple of minutes after flash is complete and the router has rebooted itself.</font></div><br>+<div style="padding-left:10px; border-color:red; border-width:4px; border-style:dotted; font-weight:normal; padding-right:5px"><font color=red><u>WARNING</u>: '''DO NOT''' attempt to reset or power cycle the router while it is still in the process of upgrading! Wait a couple of minutes after upgrade is complete and the router has rebooted itself.</font></div><br>
====Hard Reset (aka 30/30/30 reset):==== ====Hard Reset (aka 30/30/30 reset):====
Line 12: Line 12:
Do not use configuration restore if you change firmware builds (different svn build numbers) Do not use configuration restore if you change firmware builds (different svn build numbers)
 +
 +====Erasing NVRAM:====
 +
 +As an alternative method, it is possible to restore DD-WRT to default settings without using the reset button
 +(useful when the reset button is disabled, broken, etc. or if your router just refuses to reset using 30/30/30).
 +
 +The following requires that DD-WRT already be installed on your router, and [[Telnet/SSH_and_the_Command_Line|Telnet (or SSH)]] services be enabled and accessible.
 +
 +Telnet (or SSH) into 192.168.1.1
 +
 +Issue commands:
 +
 +<pre>
 +erase nvram
 +reboot
 +</pre>
 +
 +All should be in default settings now.
[[Category: English documentation]] [[Category: English documentation]]

Revision as of 11:42, 19 August 2008

WARNING: DO NOT attempt to reset or power cycle the router while it is still in the process of upgrading! Wait a couple of minutes after upgrade is complete and the router has rebooted itself.

Hard Reset (aka 30/30/30 reset):

  • With the unit powered on, press and hold the reset button on back of unit for 30 seconds
  • Without releasing the reset button, unplug the unit and hold reset for another 30 seconds
  • Plug the unit back in STILL holding the reset button a final 30 seconds.

This will clear out the NVRAM and set the dd-wrt back to default values.

This procedure should be done BEFORE and AFTER every firmware upgrade/downgrade

Do not use configuration restore if you change firmware builds (different svn build numbers)

Erasing NVRAM:

As an alternative method, it is possible to restore DD-WRT to default settings without using the reset button (useful when the reset button is disabled, broken, etc. or if your router just refuses to reset using 30/30/30).

The following requires that DD-WRT already be installed on your router, and Telnet (or SSH) services be enabled and accessible.

Telnet (or SSH) into 192.168.1.1

Issue commands:

erase nvram
reboot

All should be in default settings now.