Firmware FAQ

From DD-WRT Wiki

(Difference between revisions)
Jump to: navigation, search
Revision as of 18:41, 5 October 2006 (edit)
AycheKay (Talk | contribs)
(Added numerous FAQ's)
← Previous diff
Revision as of 18:42, 5 October 2006 (edit) (undo)
AycheKay (Talk | contribs)

Next diff →
Line 16: Line 16:
'''How do I install DD-WRT firmware'''<br /> '''How do I install DD-WRT firmware'''<br />
-See [[Installation]]+Make sure you have a compatible router, then see [[Installation]]

Revision as of 18:42, 5 October 2006

Believe it or not, the FAQ's is the most incomplete section on the DD-WRT Wiki. Until we can further develop this section, we've posted some links to other sections of the Wiki that might help you find what you're looking for:

How can I tell if my router is truly bricked?
This is an FAQ for which we do not have an article yet.


I bricked my router? Now what?
There's a lot of variables in answering this question and we don't have articles to cover all the different situations. But, for now, first verify that it's truly bricked. Then see: Recovering from a bad flash.


Is my router supported?
See Supported Devices
Linksys WRT54G v7.0 models are not supported and probably never will be.


How do I install DD-WRT firmware
Make sure you have a compatible router, then see Installation


How do I upgrade my firmware with TFTP?
Flashing with TFTP must not be seen as the standard procedure for flashing: only use it when you are specifically told to do so (for example in the specific instructions for flashing your brand or type of device). Normally, the GUI flashing method should be used; it should be perfectly adequate for any standard situation. See Installation


What's the default username and password?
Starting with v23 SP1, the default username is root and the default password is admin.


How do I access the router's settings?
If you have DD-WRT installed, your router's settings should be accessible by opening a web browser and typing in http://192.168.1.1/ in the address bar. If you have changed the LAN IP address on the router, you'll need to type in the correct one instead of the one shown here. If your router doesn't have DD-WRT installed yet, try http://192.168.1.1/ or http://192.168.0.1/ or else consult the manufacturer's documentation.


I'm having lots of transmit errors. How can I fix that?
Try setting the Ack Timing to 0. If you have the the transmit power turned up higher than 84 mW, turn it down to 84.


How high should I set the transmit power on my router?
Somewhere around 84 mW is considered to be the best setting for maximum power with minimum noise. The forums have had discussions about what power level is safe, with little conclusion. Use common sense and don't set the power higher than you really need to. If you're trying to get more range, consider using a different antenna and make sure you have a clear line of site, two of the most critical factors in your router's range.





How-To's Many Walk-Throughs for Different DD-WRT Configurations
Articles Some Articles on subjects like Wireless Modes, Router Modes, etc.
Glossary Wireless Networking Terms and Definitions along with DD-WRT Feature explanations




TODO: Place the FAQ here, provide two versions. The first being a guided FAQ version for the less technically inclined to find the answer to their question, as well as a complete listing of all questions seperated by categories for the more advanced users.