Buffalo WZR-HP-AG300H
From DD-WRT Wiki
(Difference between revisions)
Revision as of 19:12, 22 May 2011 (edit) Buddee (Talk | contribs) m (arrange format, tidy up a bit) ← Previous diff |
Revision as of 00:40, 8 June 2011 (edit) (undo) Buddee (Talk | contribs) (not complete, will touch back up in a few) Next diff → |
||
Line 2: | Line 2: | ||
- | + | =WZR-HP-AG300H Hardware Info= | |
[[Image:wzr-hp-ag300h1.jpg]] [[Image:wzr-hp-ag300h2.jpg]] | [[Image:wzr-hp-ag300h1.jpg]] [[Image:wzr-hp-ag300h2.jpg]] | ||
Line 37: | Line 37: | ||
| 1x USB 2.0 | | 1x USB 2.0 | ||
|} | |} | ||
+ | |||
+ | ---- | ||
+ | |||
+ | =Flashing instructions= | ||
+ | |||
+ | This unit ships with the buffalo pro dd-wrt build 15940 pre-flashed onto the router. If you would like to use community builds for this unit (non-buffalo branded dd-wrt), then you will need to follow these steps to flash the community dd-wrt build onto the unit. And to note, this method will work for going from buffalo pro dd-wrt or buffalo user friendly firmware to community dd-wrt. | ||
+ | |||
+ | 1) Download the community dd-wrt build for this model using the link below. | ||
+ | |||
+ | ftp://ftp.dd-wrt.com/others/eko/BrainSlayer-V24-preSP2/2011/04-09-11-r16785/buffalo_wzr-hp-ag300h/buffalo_to_ddwrt_webflash-MULTI.bin | ||
+ | |||
+ | 2) Perform a reset on the router holding the reset button down for 30 seconds and then release. | ||
+ | |||
+ | 3) Set a static IP on your PC to 192.168.11.2 and subnet 255.255.255.0, gateway 192.168.11.1 | ||
+ | |||
+ | 4) |
Revision as of 00:40, 8 June 2011
This page is a WIP, please feel free to add useful infos
WZR-HP-AG300H Hardware Info
CPU | Atheros AR7161 |
---|---|
CPU Speed | 680 MHz |
Flash ROM | 32 MB |
RAM | 128 MB |
Radios | 1x 2.4 GHz / 1x 5Ghz |
WLAN Support | A/B/G/N |
WLAN Max Speed | 300 mbps |
Antenna Location | 2x fixed external |
Switch | 4x GigE + 1 WAN |
USB | 1x USB 2.0 |
Flashing instructions
This unit ships with the buffalo pro dd-wrt build 15940 pre-flashed onto the router. If you would like to use community builds for this unit (non-buffalo branded dd-wrt), then you will need to follow these steps to flash the community dd-wrt build onto the unit. And to note, this method will work for going from buffalo pro dd-wrt or buffalo user friendly firmware to community dd-wrt.
1) Download the community dd-wrt build for this model using the link below.
2) Perform a reset on the router holding the reset button down for 30 seconds and then release.
3) Set a static IP on your PC to 192.168.11.2 and subnet 255.255.255.0, gateway 192.168.11.1
4)