Buffalo WLI-TX4-G54HP

From DD-WRT Wiki

Revision as of 17:43, 8 January 2011 by Rdblue (Talk | contribs)
Jump to: navigation, search


Basic info

Adding a WAN port

It is possible to change one of the 4 default LAN ports into a WAN port. The typical disclaimers apply; messing with this stuff could brick your unit.


This procedure was tested using v24-SP2, release 08/07/10 (SVN revision: 14896), with the VPN build.

Facts you should know:

  • eth0 is the interface to access all physical network ports
  • eth1 is the wireless network interface
  • vlan0 is the virtual network device that represents LAN ports. It's "real" device is eth0.
  • vlan1 is the virtual network device that represents WAN ports. It's "real" device is also eth0.


1. Install dd-wrt, turn on the SSH server, and set your public key.

2. SSH into the router.

3. Update the boardflags from 0x3658 to 0x3758 (add 0x0100):

root@wli-tx4-g54hp:~# nvram get boardflags
root@wli-tx4-g54hp:~# nvram set boardflags="0x3758"
root@wli-tx4-g54hp:~# nvram commit
Adding 0x0100 is necessary because the hardware doesn't have a WAN port and the firmware is initially configured without VLAN support. I tried this because the hardware is basically the same as the WHR-HP-G54, which supports VLANs. This is the crucial step; otherwise, everything is set up to use eth0, which treats all physical network ports the same.

4. Reboot. After booting, there should now be a "VLAN" tab under "Setup" and there should be two new interfaces in the "Networking" tab: vlan0 and vlan1.

After this point, the remaining steps configure the router to be just like other routers that have a WAN port, with one exception: we map an additional port to the WAN network since there is no WAN port (vlan1).

5. In the Setup > VLAN tab of the web interface, change the assigned bridge of the first line (vlan0) to "LAN".

6. Uncheck port 4 from the first line (vlan0), and check it in the second line (vlan1). This configures port 4 as a WAN port and the others as LAN ports.

7. Save and open the Setup > Networking tab.

8. Under "Port Setup", set the "WAN Port Assignment" to vlan1.

9. Save and reboot the router.

10. SSH into the router.

11. Make some final changes that can't be done through the GUI. Specifically, remove eth0 from the bridge and replace it with vlan0. This bridges the LAN ports with the wireless network.

root@wli-tx4-g54hp:~# nvram get ifnames
eth0 eth1
root@wli-tx4-g54hp:~# nvram set ifnames="vlan0 eth1"
root@wli-tx4-g54hp:~# nvram commit


See also

#define BFL_ENETVLAN 0x00000100 /* Board has VLAN capability */