Buffalo WBR-G54 WLA-G54 WLA-G54C WBR2-G54 WBR2-G54S
From DD-WRT Wiki
(Difference between revisions)
Revision as of 09:16, 2 November 2005 (edit) 194.249.53.249 (Talk) ← Previous diff |
Revision as of 09:43, 2 November 2005 (edit) (undo) Eko (Talk | contribs) Next diff → |
||
Line 1: | Line 1: | ||
'''Work in progress ---- stay tuned''' | '''Work in progress ---- stay tuned''' | ||
+ | |||
+ | '''WARNING: The Buffalo is not yet officially supported: USE AT YOUR OWN ?ISK!!!''' | ||
+ | |||
+ | '''WARNING: After flash the WAN and LAN port could be temporaly swapped''' | ||
Line 20: | Line 24: | ||
2) Buffalo default IP address: Default IP addres is 192.168.11.1. Router will also listen to this address during boot. It will answer to pings with TTL=128. | 2) Buffalo default IP address: Default IP addres is 192.168.11.1. Router will also listen to this address during boot. It will answer to pings with TTL=128. | ||
+ | |||
+ | |||
+ | '''3) Flashing''' | ||
+ | |||
+ | Before flashing be sure to restore to factory defaults. Also check if you can connect to the router wirelessly. | ||
+ | |||
+ | 3a) Flashing using tftp: | ||
+ | |||
+ | Use the original DD-WRT generic version. Load it at boot time at 192.168.11.1. After succesful transfer please wait 2-3 min., or util router reboots. | ||
+ | |||
+ | 3b) Flashing using Buffalo's WEB interface: | ||
+ | |||
+ | Use the DD-WRT generic version with added 34 bytes header. After succesful transfer please wait 2-3 min., or util router reboots. | ||
+ | |||
+ | |||
+ | '''4) After flash:''' | ||
+ | |||
+ | You will be able to access the router at 192.168.11.1. '''Do not restore to factory default or clear nvram!''' | ||
+ | |||
'''Work in progress ---- stay tuned''' | '''Work in progress ---- stay tuned''' |