Alfa N5
From DD-WRT Wiki
(Difference between revisions)
Revision as of 13:42, 22 June 2014 (edit) Sash (Talk | contribs) ← Previous diff |
Revision as of 13:43, 22 June 2014 (edit) (undo) Sash (Talk | contribs) Next diff → |
||
Line 2: | Line 2: | ||
'''= Planet WNAP-7320 = OTAi 724S''' | '''= Planet WNAP-7320 = OTAi 724S''' | ||
+ | |||
+ | This instruction is also valid for the '''Alfa N5c''' | ||
=Hardware= | =Hardware= | ||
*CPU Atheros AR7240 | *CPU Atheros AR7240 | ||
- | *Flash 8MB | + | *Flash 8MB |
- | *RAM 32 MB | + | *RAM 32 MB |
- | + | ||
==Serial Port== | ==Serial Port== |
Revision as of 13:43, 22 June 2014
Contents |
= Planet WNAP-7320 = OTAi 724S
This instruction is also valid for the Alfa N5c
Hardware
- CPU Atheros AR7240
- Flash 8MB
- RAM 32 MB
Serial Port
115000,1,n,8
1 PWR 2 TX 3 RX 4 GND
Flashing
Initial
For initial flashing you have to access the device via serial connection.
U-Boot
Since the default is set to boot from the fixed address 0x9f650000, an new bootloader must be flashed before you can boot DD-WRT. Process each line step by step from the uboot console:
tftpboot 0x80060000 uboot.bin erase 9f000000 +$filesize cp.b $fileaddr 0x9f000000 $filesize
The old verseion is and the new one will be U-Boot 1.1.4t
DD-WRT/Recovery
Afer the uboot is flashed go on installing DD-WRT from the cli:
tftp 0x80060000 firmware.bin erase 9f050000 +$filesize cp.b $fileaddr 0x9f050000 $filesize