Alfa N5
From DD-WRT Wiki
(Difference between revisions)
Revision as of 13:46, 22 June 2014 (edit) Sash (Talk | contribs) (→U-Boot) ← Previous diff |
Revision as of 13:53, 22 June 2014 (edit) (undo) Sash (Talk | contribs) (→U-Boot) Next diff → |
||
Line 26: | Line 26: | ||
===U-Boot=== | ===U-Boot=== | ||
Since the default is set to boot from the fixed address 0x9f650000, an new bootloader must be flashed before you can boot DD-WRT. | Since the default is set to boot from the fixed address 0x9f650000, an new bootloader must be flashed before you can boot DD-WRT. | ||
+ | You will have to setup an tftp server where you can download the files. When the cli asks type 1 to enter the command line. print the envsettings and set the ip and server address. | ||
Process each line step by step from the uboot console: | Process each line step by step from the uboot console: | ||
Line 32: | Line 33: | ||
cp.b $fileaddr 0x9f000000 $filesize | cp.b $fileaddr 0x9f000000 $filesize | ||
+ | when the download doesnt work, try again with the 2nd eth port. | ||
The new version will be U-Boot 1.1.4 <br> | The new version will be U-Boot 1.1.4 <br> | ||
'''Dont reset/reboot yet!''' | '''Dont reset/reboot yet!''' |
Revision as of 13:53, 22 June 2014
Contents |
= Planet WNAP-7320 = OTAi 724S
This instruction is also valid for the Alfa N5c
Hardware
- CPU Atheros AR7240
- Flash 8MB
- RAM 32 MB
Serial Port
115000,1,n,8
1 PWR 2 TX 3 RX 4 GND
Flashing
Initial
For initial flashing you have to access the device via serial connection.
U-Boot
Since the default is set to boot from the fixed address 0x9f650000, an new bootloader must be flashed before you can boot DD-WRT. You will have to setup an tftp server where you can download the files. When the cli asks type 1 to enter the command line. print the envsettings and set the ip and server address. Process each line step by step from the uboot console:
tftpboot 0x80060000 uboot.bin erase 9f000000 +$filesize cp.b $fileaddr 0x9f000000 $filesize
when the download doesnt work, try again with the 2nd eth port.
The new version will be U-Boot 1.1.4
Dont reset/reboot yet!
DD-WRT/Recovery
Afer the uboot is flashed go on installing DD-WRT from the cli:
tftp 0x80060000 firmware.bin erase 9f050000 +$filesize cp.b $fileaddr 0x9f050000 $filesize