Alfa N5
From DD-WRT Wiki
(Difference between revisions)
Revision as of 13:16, 22 June 2014 (edit) Sash (Talk | contribs) (New page: __TOC__ =Hardware= *CPU Atheros AR7240 *Flash 8MB S25FL032A http://www.spansion.com/Support/Datasheets/S25FL032A_00_C3_e.pdf *RAM 32 MB M12L128168A http://www.esmt.com.tw/DB/manager/up...) ← Previous diff |
Revision as of 13:24, 22 June 2014 (edit) (undo) Sash (Talk | contribs) Next diff → |
||
Line 1: | Line 1: | ||
__TOC__ | __TOC__ | ||
+ | '''= Planet WNAP-7320''' | ||
=Hardware= | =Hardware= | ||
Line 36: | Line 37: | ||
erase 9f050000 +$filesize | erase 9f050000 +$filesize | ||
cp.b $fileaddr 0x9f050000 $filesize | cp.b $fileaddr 0x9f050000 $filesize | ||
+ | |||
+ | |||
+ | [[Category:Alfa Network guides]] |
Revision as of 13:24, 22 June 2014
Contents |
= Planet WNAP-7320
Hardware
- CPU Atheros AR7240
- Flash 8MB S25FL032A http://www.spansion.com/Support/Datasheets/S25FL032A_00_C3_e.pdf
- RAM 32 MB M12L128168A http://www.esmt.com.tw/DB/manager/upload/M12L128168A.pdf
- Ethernet RTL8201CP http://www.realtek.info/pdf/rtl8201cp.pdf
Serial Port
115000,1,n,8
1 PWR 2 TX 3 RX 4 GND
Flashing
Initial
For initial flashing you have to access the device via serial connection.
U-Boot
Since the default is set to boot from the fixed address 0x9f650000, an new bootloader must be flashed before you can boot DD-WRT. Process each line step by step from the uboot console:
tftpboot 0x80060000 uboot.bin erase 9f000000 +$filesize cp.b $fileaddr 0x9f000000 $filesize
DD-WRT/Recovery
Afer the uboot is flashed go on installing DD-WRT from the cli:
tftp 0x80060000 firmware.bin erase 9f050000 +$filesize cp.b $fileaddr 0x9f050000 $filesize