AP Repeater on DLINK Dir-300

From DD-WRT Wiki

(Difference between revisions)
Jump to: navigation, search
Revision as of 09:07, 30 April 2010 (edit)
Glenn (Talk | contribs)
← Previous diff
Current revision (09:43, 31 May 2014) (edit) (undo)
Glenn (Talk | contribs)

(One intermediate revision not shown.)
Line 1: Line 1:
-== How to configure DLINK DIR-300 as AP Repeater ==+{{delete|Has been emtied by sash.}}
- +
-I Have been researching because I need to use my DLINK Dir-300 as a Repeater Bridge+
-This operation mode is easily to find in a broadcom based hardware such as linksys, etc, BUT you can not set "Repeater Bridge" Mode on a Dir-300+
- +
-So Here's how to make the stuff :+
- +
-I Assume that you already have an AP working under your administration.+
-Lets say that this AP SSID is "AP1" With a LAN IP ADDRESS of
- +
-Ok, starting with that you have to go to your DIR-300 Configuration Page, now go to the "Setup" tab, now on "Wan Connection Type" On connection type, select '''DISABLED'''+
-On "Network Setup"+
-"Local IP address" (the LAN IP of the DIR-300) of course it got to be on the same network as LAN on "AP1"+
-"Subnet mask" The same subnet mask used in LAN for AP1+
-'''here is the important thing :'''+
-On "Gateway" you have to write the IP address of AP1 LAN Address+
-On "Local DNS" you have to write the IP address of AP1 LAN Address+
- +
-Next you have to DISABLE the DCHP server on DIR-300+
- +
-Finally Click on "Save" and "Apply Settings"+
- +
-Now we move to the tab "Wireless" on the DIR-300+
-once there you have to modify Wireless Mode drop down box and select "CLIENT BRIDGE"+
-Now you have to go to Wireless Network Name (SSID) and write the SSID of AP1+
-Now go to "Virtual Interfaces" and do a click on ADD+
-next write a name (SSID) for this virtual interface it could be Any SSID that you want to, included AP1 SSID+
- +
-Now it's time to SAVE SETTINGS do not click on APPLY YET.+
- +
-Now you have to go to "Status" Tab , Now Wireless menu, at the botton on the page you will find the "Site Survey" Button do a click on it, you will of course find AP1 SSID and the chance to JOIN, do a click on Join to AP1+
- +
-Now you have to go back to the "Wireless TAB" and do a click on "Apply Settings"+
-And that's it.+
- +
-Now you have a DIR-300 Working as a repeater of AP1.+
- +
-If you have any comments you can contact me on m_semino@hotmail.com+
- +
-[[Category:D-Link guides]]+

Current revision

This page or file is a candidate for deletion. The given reason is: Has been emtied by sash.

This notice should remain for a minimum of 1 week after it was placed on the page. If discussion is still ongoing, it should remain until a consensus is reached, after which the page will either be deleted or this notice removed.

If you disagree with its deletion, please discuss your reasons on this page or on its associated talk page, as applicable.

Remember to check if anything links here and the page history before deleting.