Search results

From DD-WRT Wiki

You searched for DHCP

Jump to: navigation, search

There is no page titled "DHCP". You can create this page.

For more information about searching DD-WRT Wiki, see Help.

Showing below up to 20 results starting with #1.


View (previous 20) (next 20) (20 | 50 | 100 | 250 | 500).

Article title matches

  1. Static DHCP (7,109 bytes)
    1: {{languages|Static_DHCP}}
    4: ...equests its IP from the router's DHCP server. The DHCP server recognizes the MAC address of your device'...
    6: ...P, and this can be achieved easily through Static DHCP.
    13: # DHCP Daemon should be enabled
    18: [[Image:DHCP_Static_Lease_GUI_-_build_15704.png|center]]
  2. DNSMasq als DHCP Server (3,337 bytes)
    1: {{Languages|DNSMasq as DHCP server}}
    2: ...her im Umfang von etwa 300kb sparen, wenn dafür udhcpd abschaltet. 300kb sind nicht viel, wird jetzt de...
    4: 1. Man deaktiviere den DHCPD-Dienst auf der "Setup" Seite.
    8: dhcp-range=192.168.0.100,192.168.0.150,255.255.255.0,1...
    15: dhcp-host=AB:CD:EF:11:22:33,192.168.0.10,host,host.dom...
  3. DNSMasq as DHCP server (13,849 bytes)
    1: {{Languages|DNSMasq as DHCP server}}
    2: ...CP service [http://udhcp.busybox.net/ "udhcpd"]. uDHCPd uses more RAM than DNSMasq.
    4: Using DNSMasq as the sole DHCP server can save you 300kB. With this savings you ...
    6: ... local name lookups for any DHCP client, [[Static_DHCP|static]] or dynamic.
    8: ...ups require that the router run udhcpc to acquire DHCP leases for the WAN interface.
  4. WLAN separate from LAN, with independent dhcp, etc (8,617 bytes)
    11: ...separate subnets for wired and wireless, separate dhcp, etc.
    13: Contrary to popular belief, DHCPMasq is quite capable of serving different ip rang...
    29: ...fi on a separate subnet from my LAN, with its own DHCP scope. In these examples, lan is 192.168.7.0/24, ...
    43: dhcp-script=/etc/lease_update.sh
    44: dhcp-lease-max=50
  5. V24: WLAN separate from LAN, with independent DHCP (6,354 bytes)
    19: ...Scroll to the bottom and click Add under Multiple DHCP Server. This will bring up several new options. S...
    35: ...th wifi clients not being able to acquire IP from DHCP. I found out that there was a problem with the na...
    88: ... lease (Note: I use DNSmasq DHCP, for I have the 'DHCP Server' disabled on the LAN segment; see [[Separa...
  6. Static DHCP/zh cn (5,604 bytes)
    1: {{languages|Static_DHCP}}
    2: 首先,英文版本的Static DHCP图片取自V23,落后了,所以一张截图...
    3: ...//en.wikipedia.org/wiki/MAC_address MAC地址] 。DHCP服务器确认您网卡的MAC地址并将静态IP...
    5: ...服务器一个静态的IP,这可以通过静态DHCP容易。
    6: ... v24-sp2 (10/10/09) mega(SVN revision 13064)静态DHCP设置页面,leangjia截图]]
  7. DNSMasq as DHCP server/zh cn (9,391 bytes)
    1: {{Languages|DNSMasq as DHCP server}}
    2: ...CP service [http://udhcp.busybox.net/ "udhcpd"]. uDHCPd uses more RAM than DNSMasq.
    4: Using DNSMasq as the sole DHCP server can save you 300kB. With this savings you ...
    6: ... local name lookups for any DHCP client, [[Static_DHCP|static]] or dynamic.
    8: ...ups require that the router run udhcpc to acquire DHCP leases for the WAN interface.

Page text matches

  1. DD-WRT Doku (DE) (83,042 bytes)
    225: *Statische DHCP-Adresszuweisung
    534: ...hl bei "DNS-Server automatisch beziehen", um eine DHCP-IP-Adresse vom Router zu erhalten. Oder wechseln ...
    652: ...outer*[Bemerkung] - being a bridged setup and all DHCP is being done by the host AP - it is possible to ...
    671: ..."-> "Netzwerke" bei Punkt "DHCPD" einen multiblen DHCP Server hinzufügen!*'''APPLY Settings'''
    672: #Am Client noch DHCP einstellen, so hat es bei mir funktioniert! Viel ...
  2. Beschreibung der einzelnen Einstellungen (dd-wrt (18,677 bytes)
    11: ...ie Internet-Anbindung, sprich den WAN-Port. Neben DHCP gibts auch PPPoE, PPTP, L2TP, statische IP oder d...
    179: <u>Dhcpd</u><br>
    180: ...Dämon des WRT, u.a. kann man hier auch statische DHCP-Adressen vergeben.
    185: ...t DHCP Rechner im LAN um statische und dynamische DHCP-Hostnamen aufzulösen.
    201: ...r. Dieser Adressbereich sollte sich nicht mit den DHCP-Adressen überschneiden. (z.B. 192.168.1.230-240)...
  3. Alphabetischer Index (1,432 bytes)
    26: *[[DNSMasq als DHCP Server]]
  4. Static PPTP VPN Client (18,128 bytes)
    38: ...o have set IPs in this setup is to use the static DHCP option.
  5. Verizon FIOS setup with dd-wrt as primary router (5,626 bytes)
    17: ...ill have to contact Verizon to release/renew your DHCP connection on their side….By cloning the MAC ad...
    19: 5 – On the AT you can leave the DHCP turned on for the “Network (Home/Office)” sid...
  6. Tutorials (9,700 bytes)
    33: * [[DNSMasq as DHCP server]]
    75: * [[Static DHCP]]
    136: ...E|PXE - Allow thin clients to boot using DD-WRT's DHCP service]]
  7. Skript-Schnipsel (15,104 bytes)
    147: ...nur, wenn der Wireless-Client eine IP-Adresse vom DHCP-Server bekommen hat (daher dumpleases).''
  8. Recover from a bad flash (41,825 bytes)
    71: ...8.1.x" is good. If you do not have a good IP, the DHCP Server might not be working. So set your IP manua...
    279: ...en it should assign your computer an address with DHCP.
    459: ...t cable interface from static IP settings back to DHCP, wait a few seconds for the network interface res...
  9. Client Mode (5,465 bytes)
    11: A Client Mode router uses its own DHCP server for IP Address, Gateway, and DNS server to...
    31: ...'' to ''Static IP'' or "Automatic Configuration - DHCP"
    33: ...rt protocol as needed for the AP (usually Static, DHCP, or PPPoE), and enter info provided by your ISP. ...
  10. Glossary (58,851 bytes)
    113: ...ntly, NAT is no longer used and services (such as DHCP) that are running on the original network will wo...
    145: ===DHCP Server===
    148: ===DHCP Forwarder===
    149: ... server, rather than needing multiple distributed DHCP servers for their routers.
    171: ...k. Because most ISPs provide IP addresses through DHCP (or charge extra for a static IP address) your IP...
  11. WDS Linked router network (21,578 bytes)
    38: ...AP and WDS Station. Use any number outside of the DHCP range (default range is 192.168.1.100 to 192.168....
    73: ... the same subnet as the WDS AP but outside of its DHCP range (Ex: 192.168.1.2, if using the default rang...
    77: * Uncheck all of the check boxes under DHCP
    78: * Disable the DHCP Server
    149: ...s (DHCP) . Also Uncheck the Three boxes below the DHCP Server.
  12. Chillispot (36,629 bytes)
    74: ...sting LAN is left completely alone. If you have a DHCP server or some custom corporate setup and you don...
    95: ...N Bridge" is disabled, the DD-WRT device's normal DHCP Server must be off.'''
    101: ...n page) of the Web Interface, turn off the DD-WRT DHCP Server.
    102: ...virtual LAN interface at 192.168.1.1 and provides DHCP Services again on 192.168.1.x for all your Wirele...
    107: #'''DHCP Interface''': select "LAN" this is the bridge bet...
  13. Port Forwarding (14,856 bytes)
    56: ...to set your static IPs outside of your automatic (DHCP) address range. This range is 192.168.1.100-192.1...
    90: ...g to is configured by for automatic IP address by DHCP, you will periodically have to update the last fi...
  14. Iptables command (26,353 bytes)
    96: ...tion steps are targeted toward users with a basic DHCP connection for the WAN part. So, if using PPPoE w...
    410: ==Firewall blocks DHCP renewal responses==
    413: ... DHCP renewal responses which causes the router's DHCP client to request a new IP and for current connec...
  15. Separate LAN and WLAN (outdated) (15,294 bytes)
    29: Enable DHCP for 192.168.1.x for vlan0
    30: Enable DHCP for 192.168.2.x for eth1
    39: Set ''wifi_proto'' to dhcp or static (run dhcp for wifi hosts?)
    47: Enable DHCP for <wireless_network> for eth1
    62: Enable DHCP for <lan_adapter_network> for vlan0
  16. IPv6 (tutorial) (36,073 bytes)
    28: Radvd is similar to a DHCP server. It advertises your IPv6 prefix to the lo...
    97: ...tion steps are targeted toward users with a basic DHCP connection for the WAN part. So, if using PPPoE w...
    106: Radvd is similar to a DHCP server. It advertises your IPv6 prefix to the lo...
  17. OpenVPN (28,200 bytes)
    183: ...ients use the network dhcp server not the openvpn dhcp. {} []
    189: ;Block DHCP accross the tunnel: Dont allow DHCP requests across tunnel (Only in bridge mode).
    345: ipconfig set $1 DHCP
    353: ... the TAP interface to request an IP address using DHCP. Make sure to make the script executable with 'ch...
    357: ...to your internal LAN. If your router is running a DHCP server, the TAP interface will be assigned an IP ...
  18. Firewall (8,046 bytes)
    49: ... and ip configurations are leased to clients by a DHCP server.
    50: ...ith some ip configuration normally acquired via a DHCP client.
    58: ...[:Category:PPPOE|PPPoE client]], [[:Category:DHCP|DHCP server(s) or client]] and so on.
  19. Static DHCP (7,109 bytes)
    1: {{languages|Static_DHCP}}
    4: ...equests its IP from the router's DHCP server. The DHCP server recognizes the MAC address of your device'...
    6: ...P, and this can be achieved easily through Static DHCP.
    13: # DHCP Daemon should be enabled
    18: [[Image:DHCP_Static_Lease_GUI_-_build_15704.png|center]]
  20. Bootvorgang (68,911 bytes)
    152: info, udhcp server (v0.9.8) started
    215: Hit enter to continue...info, udhcp client (v0.9.8) started
    788: to set this information via DHCP.
    792: ...auto Configure interface automatically via DHCP
    1059: info, udhcp server (v0.9.8) started

View (previous 20) (next 20) (20 | 50 | 100 | 250 | 500).



Search in namespaces:

List redirects
Search for