Asus RT-N15
From DD-WRT Wiki
Contents |
NOTE: This device is a WIP.
NOTE: Requires K2.6, Do not flash anything else.
NOTE: During configuration or flashing a device, the only things that should be hooked to the device is the computer and power.
[edit] Specs
See wikidevi page for full specs: https://wikidevi.com/wiki/ASUS_RT-N15
[edit] Threads of interest
[edit] Flashing
The device is stitched from windows Firmware update in an official insertion (the version of an insertion 1.0.0.7)
Firmware files can be found here: Where do I download firmware? (asus-rt-n15 folder). Use the factory-to-ddwrt.trx to flash from Factory firmware to dd-wrt.
[edit] Upgrading
Firmware files can be found here: Where do I download firmware? (asus-rt-n15 folder). Use the asus-rt-n15-ddwrt-webflash.bin file to upgrade dd-wrt to a newer version.
[edit] Reverting
To restore the device to factory firmware, you need to put it in Recovery Mode.
- Download the factory firmware
- In dd-wrt, reset to factory defaults, through the GUI or CLI.
- Disconnect everything from the router, except the power cord.
- Push and hold the Reset button with the router powered on. Without releasing the Reset button, unplug the router.
- Wait until the power light starts blinking, then release the Reset button.
- (Not tested, most likely access a webpage at 192.168.0.1 or 192.168.1.1) We launch program Restoration Firmware, we select a file with an insertion, we stitch.
- (Not tested) Browse to the factory firmware file. Click the Upload button.
- (Not tested) Wait at least 5 minutes before touching the power cord.
- (Not tested) Do a factory reset once the router comes back up successfully.
[edit] JTAG/Serial Info
[edit] JTAG
This router does not have JTAG.
[edit] Serial
[edit] Serial Pinouts
Serial console is available on J1, pinout is as follows :
RT2880 [x] GND [x] TX [x] RX [x] VCC
Serials console baudrate is a bit unusual : 57600,8n1.
[edit] Serial Recovery
See Serial Recovery